Configuring Trunk Group Settings - AudioCodes Mediant 500 E-SBC User Manual

User's Manual
Parameter
Trunk Group ID
CLI: trunk-group-id
[TrunkGroup_TrunkGroupNum]
Tel Profile ID
CLI: tel-profile-id
[TrunkGroup_ProfileId]
22.2

Configuring Trunk Group Settings

The Trunk Group Settings table lets you configure various settings per Trunk Group. The
main settings include:

Channel select method, which defines how the device allocates IP-to-Tel calls to the
channels of a Trunk Group.

Registration method for registering Trunk Groups to remote IP servers (Serving IP
Group).
For configuring Trunk Groups, see Configuring Trunk Group Table on page 347.
The following procedure describes how to configure settings for Trunk Groups in the Web
interface. You can also configure this using the table ini file parameter, TrunkGroupSettings
or CLI command, configure voip/gw hunt-or-trunk-group trunk-group-setting.

To configure settings for Hunt Group Settingss:
1. Open the Trunk Group Settings page (Configuration tab > VoIP menu > GW and IP
to IP > Trunk Group > Trunk Group Settings).
2. Configure a Trunk Group according to the parameters described in the table below.
3. Click Submit, and then save ("burn") your settings to flash memory.
Table 22-2: Trunk Group Settings Parameter Descriptions
Parameter
Trunk Group ID
CLI: trunk-group-id
[TrunkGroupSettings_TrunkGr
Version 6.8
Defines the Trunk Group ID for the specified channels. The
same Trunk Group ID can be assigned to more than one group
of channels. If an IP-to-Tel call is assigned to a Trunk Group,
the IP call is routed to the channel(s) pertaining to that Trunk
Group ID.
The valid value can be 0 to 119.
Assigns a Tel Profile ID to the Trunk Group.
Note: For configuring Tel Profiles, see ''Configuring Tel
Profiles'' on page 297.
Defines the Trunk Group ID that you want to configure.
349
Description
Description
Mediant 500 E-SBC
22. Trunk Group