General Sas Configuration; Enabling The Sas Application; Configuring Common Sas Parameters - AudioCodes Mediant 3000 User Manual

20.2.1 General SAS Configuration

This section describes the general configuration required for the SAS application. This
configuration is applicable to all SAS modes.

20.2.1.1 Enabling the SAS Application

Before you can configure SAS, you need to enable the SAS application on the device.
Once enabled, the device's Web interface provides the SAS pages for configuring SAS.
Note:

To enable the SAS application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'Enable SAS' drop-down list, select Enable.
3. Click Submit.
4. Save the changes to the flash memory with a device reset; after the device resets, the
SAS menu appears and you can now begin configuring the SAS application.

20.2.1.2 Configuring Common SAS Parameters

The procedure below describes how to configure SAS settings that are common to all SAS
modes. This includes various SAS parameters as well as configuring the Proxy Set for the
SAS proxy (if required). The SAS Proxy Set ID defines the address of the UAs' external
proxy.

To configure common SAS settings:
1. Open the SAS Configuration page (Configuration tab > VoIP menu > SAS > Stand
Alone Survivability).
2. Define the port used for sending and receiving SAS messages. This can be any of the
following port types:
•
UDP port - defined in the 'SAS Local SIP UDP Port' field
•
TCP port - defined in the 'SAS Local SIP TCP Port' field
•
TLS port - defined in the 'SAS Local SIP TLS Port' field
SIP User's Manual
The SAS application is available only if the device is installed with the SAS
Software Upgrade Key. If your device is not installed with the SAS feature,
contact your AudioCodes representative.
450
Mediant 3000
Document #: LTRT-89712