AudioCodes Mediant 3000 User Manual page 552

Parameter
Web/EMS: Native VLAN ID
[VLANNativeVLANID]
[EnableNTPasOAM]
[VLANSendNonTaggedOnNative]
SIP User's Manual

If this parameter is enabled, separate physical networks
for Media, OAMP, and Control network types (using the
parameter EnableNetworkPhysicalSeparation) is
disabled.

VLANs are available only when booting the device from
flash. When booting using BootP/DHCP protocols, VLANs
are disabled to allow easier maintenance access. In this
scenario, multiple network interface capabilities (including
IPv6) are unavailable.
Defines the VLAN ID to which untagged incoming traffic is
assigned. Outgoing packets sent to this VLAN are sent only
with a priority tag (VLAN ID = 0).
When this parameter is equal to one of the VLAN IDs in the
Multiple Interface table (and VLANs are enabled), untagged
incoming traffic is considered as incoming traffic for that
interface. Outgoing traffic sent from this interface is sent with
the priority tag (tagged with VLAN ID = 0).
When this parameter is different from any value in the 'VLAN
ID' column in the table, untagged incoming traffic is
discarded and all outgoing traffic is tagged.
Note: If this parameter is not set (i.e., default value is 1), but
one of the interfaces has a VLAN ID configured to 1, this
interface is still considered the 'Native' VLAN. If you do not
wish to have a 'Native' VLAN ID and want to use VLAN ID 1,
set this parameter to a value other than any VLAN ID in the
table.
Defines the application type for NTP services.

[1] = OAMP (default)

[0] = Control.
Note: For this parameter to take effect, a device reset is
required.
Determines whether to send non-tagged packets on the
native VLAN.

[0] = Sends priority tag packets (default).

[1] = Sends regular packets (with no VLAN tag).
Note: For this parameter to take effect, a device reset is
required.
552
Description
Document #: LTRT-89712
Mediant 3000