AudioCodes Mediant 3000 User Manual page 623

SIP User's Manual
Parameter
[RTPOnlyModeForTrunk_ID
]
Web/EMS: Media IP Version
Preference
[MediaIPVersionPreference
]
Web/EMS: SIT Q850 Cause
[SITQ850Cause]
Web/EMS: SIT Q850 Cause
For NC
[SITQ850CauseForNC]
Web/EMS: SIT Q850 Cause
For IC
[SITQ850CauseForIC]
Version 6.4
ProtocoType parameter to 5 or 6).

Enable the TDM-over-IP feature (set the EnableTDMoverIP
parameter to 1).

To configure the RTP Only mode per trunk, use the
RTPOnlyModeForTrunk_ID parameter.

If per trunk configuration (using the RTPOnlyModeForTrunk_ID
parameter) is set to a value other than the default, the
RTPOnlyMode parameter value is ignored.
Enables the RTP Only feature per trunk, where ID depicts the trunk
number (0 is the first trunk). For more information, see the
RTPOnlyMode parameter.
Note: For using the global parameter (i.e., setting the RTP Only
feature for all trunks), set this parameter to -1 (default).
Determines the preferred RTP media IP addressing version for
outgoing SIP calls. This is indicated in the "c=" field (Connection
Information) of the SDP.

[0] Only IPv4 = offer includes only IPv4 media IP addresses
(default).

[1] Only IPv6 = offer includes only IPv6 media IPs addresses.

[2] Prefer IPv4 = offer includes both IPv4 and IPv6 media IP
addresses, but the first media is IPv4.

[3] Prefer IPv6 = offer includes both IPv4 and IPv6 media IP
addresses, but the first media is IPv6.
Notes:

This parameter is applicable only when the device offers an SDP.

The IP addressing version is determined according to the first SDP
"m=" field.

This parameter can be configured per IP Profile, using the
parameter IPProfile (see Configuring IP Profiles on page 236).
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when a Special Information Tone
(SIT) is detected on an IP-to-Tel call.
The valid range is 0 to 127. The default value is 34.
Note: For mapping specific SIT tones, you can use the
SITQ850CauseForNC, SITQ850CauseForIC, SITQ850CauseForVC,
and SITQ850CauseForRO parameters.
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-NC (No Circuit Found
Special Information Tone) is detected from the PSTN for IP-to-Tel
calls.
The valid range is 0 to 127. The default value is 34.
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
Defines the Q.850 cause value specified in the SIP Reason header
that is included in a 4xx response when SIT-IC (Operator Intercept
Special Information Tone) is detected from the PSTN for IP-to-Tel
calls.
The valid range is 0 to 127. The default value is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause
parameter is used.
623
32. Viewing Syslog Messages
Description
November 2011