Configuring Ip Security Associations Table - AudioCodes Mediant 3000 User Manual

Voip media gateway
Hide thumbs Also See for Mediant 3000:
Table of Contents

Advertisement

SIP User's Manual
11.4

Configuring IP Security Associations Table

The IP Security Associations Table page allows you to configure up to 20 peers (hosts or
networks) for IP security (IPSec)/IKE. Each of the entries in the IPSec Security Association
table controls both Main Mode and Quick Mode configuration for a single peer
Note:
To configure the IPSec Association table:
1.
Open the 'IP Security Associations Table page (Configuration tab > VoIP menu >
Security submenu > IPSec Association Table). (Due to the length of the table, the
figure below shows sections of this table.)
2.
Add an Index or select the Index rule you want to edit.
3.
Configure the rule according to the table below.
4.
Click Apply; the rule is applied on-the-fly.
5.
To save the changes to flash memory, see 'Saving Configuration' on page 478.
Table 11-4: IP Security Associations Table Configuration Parameters
Parameter Name
Operational Mode
[IPsecSATable_IPsecMode]
Remote Endpoint Addr
[IPsecSATable_RemoteEndpointAdd
ressOrName]
Version 6.4
You can also configure the IP Security Associations table using the ini file
table parameter IPsecSATable (see 'Security Parameters' on page 574).
Figure 11-4: IP Security Associations Table Page
Defines the IPSec mode of operation.
Defines the IP address or DNS host name of the peer.
Note: This parameter is applicable only if the Operational
Mode is set to Transport.
Description
[0] Transport (default)
[1] Tunnel
149
11. Security
November 2011

Advertisement

Table of Contents
loading

Table of Contents