AudioCodes Mediant 3000 User Manual page 566

Parameter
[SNMPManagerTableIP_x]
Web: Trap Port
EMS: Port
[SNMPManagerTrapPort_x
]
Web: Trap Enable
[SNMPManagerTrapSendin
gEnable_x]
[SNMPManagerTrapUser_x
]
Web: Trap Manager Host
Name
[SNMPTrapManagerHostN
ame]
SNMP Community String Parameters
Community String
[SNMPReadOnlyCommunit
yString_x]
Community String
[SNMPReadWriteCommuni
tyString_x]
Trap Community String
[SNMPTrapCommunityStri
ng]
Web: SNMP V3 Table
EMS: SNMP V3 Users
[SNMPUsers]
SIP User's Manual
Enter the IP address in dotted-decimal notation, e.g., 108.10.1.255.
Defines the port number of the remote SNMP Manager. The device
sends SNMP traps to this port.
The valid SNMP trap port range is 100 to 4000. The default port is
162.
Enables the sending of traps to the corresponding SNMP manager.

[0] Disable = Sending is disabled.

[1] Enable = Sending is enabled (default).
This parameter can be set to the name of any configured SNMPV3
user to associate with this trap destination. This determines the trap
format, authentication level, and encryption level. By default, the trap
is associated with the SNMP trap community string.
Defines an FQDN of a remote host that is used as an SNMP manager.
The resolved IP address replaces the last entry in the Trap Manager
table (defined by the parameter SNMPManagerTableIP_x) and the last
trap manager entry of snmpTargetAddrTable in the snmpTargetMIB.
For example: 'mngr.corp.mycompany.com'.
The valid range is a 99-character string.
Defines up to five read-only SNMP community strings (up to 19
characters each). The default string is 'public'.
Defines up to five read/write SNMP community strings (up to 19
characters each). The default string is 'private'.
Defines the Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
This parameter table defines SNMP v3 users. The format of this
parameter is as follows:
[SNMPUsers]
FORMAT SNMPUsers_Index = SNMPUsers_Username,
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey, SNMPUsers_Group;
[\SNMPUsers]
For example:
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
The example above configures user 'v3admin1' with security level
authNoPriv(2), authentication protocol MD5, authentication text
password 'myauthkey', and ReadWriteGroup2.
Notes:

This parameter can include up to 10 indices.

For a description of this table's individual parameters and for
configuring the table using the Web interface, see 'Configuring
SNMP V3 Users' on page 82.

For configuring ini file table parameters, see 'Configuring ini File
Table Parameters' on page
566
Description
88
Document #: LTRT-89712
Mediant 3000