SIP User's Manual
23
High Availability Maintenance
The High Availability Maintenance page allows you to perform a switch-over between the
Active and Redundant blades. In addition, this page allows you to reset the Redundant
blade.
Notes:
To perform a blade switch-over:
1.
Open the High Availability Maintenance page (Maintenance tab > Maintenance menu
> High Availability Maintenance).
2.
Under the 'Switch Over' group, click Switch Over; a confirmation box appears
requesting you to confirm.
3.
Click OK.
To reset the redundant blade:
1.
Under the 'Redundant Options' group, click Reset; a confirmation box appears
requesting you to confirm.
2.
Click OK.
Version 6.4
•
When performing a blade switchover or a Redundant blade reset, the HA
mode becomes temporarily unavailable.
•
This page can also be accessed from the toolbar's Device Actions drop-
down menu options - Switch Over and Reset Redundant (refer to
'Toolbar' on page 42).
Figure 23-1: High Availability Maintenance Page
23. High Availability Maintenance
479
November 2011