AudioCodes Mediant 3000 User Manual page 323

SIP User's Manual
An example of a Dial Plan file with indices (in ini-file format before conversion to binary
.dat) is shown below:
[ PLAN1 ]
; Area codes 02, 03, - phone numbers include 7 digits.
02,7
03,7
; Cellular/VoIP area codes 052, 054 - phone numbers include 8
digits.
052,8
054,8
; International prefixes 00, 012, 014 - number following
prefix includes 7 to 14 digits.
00,7-14
012,7-14
014,7-14
; Emergency number 911 (no additional digits expected).
911,0
[ PLAN2 ]
; Supplementary services such as Call Camping and Last Calls
(no additional digits expected), by dialing *41, *42, or *43.
*4[1-3],0
Notes:
Version 6.4
•
If you are using an external Dial Plan file for dialing plans (see 'External
Dial Plan File' on page 322), the device first attempts to locate a
matching digit pattern in the Dial Plan file, and if not found, then attempts
to locate a matching digit pattern in the Digit Map (configured by the
DigitMapping parameter).
•
It may be useful to configure both Dial Plan file and Digit Maps. For
example, the Digit Map can be used for complex digit patterns (which are
not supported by the Dial Plan) and the Dial Plan can be used for long
lists of relatively simple digit patterns. In addition, as timeout between
digits is not supported by the Dial Plan, the Digit Map can be used to
define digit patterns (MaxDigits parameter) that are shorter than those
defined in the Dial Plan, or left at default. For example, "xx.T" Digit Map
instructs the device to use the Dial Plan and if no matching digit pattern,
it waits for two more digits and then after a timeout (TimeBetweenDigits
parameter), it sends the collected digits. Therefore, this ensures that calls
are not rejected as a result of their digit pattern not been completed in the
Dial Plan.
•
For E1 CAS MFC-R2 variants (which don't support terminating digit for
the called party number, usually I-15), the external Dial Plan file and the
DigitMapping parameter are ignored. Instead, you can define a Dial Plan
template per trunk using the parameter CasTrunkDialPlanName_x.
323
18. GW and IP to IP
November 2011