Metering Tone Parameters - AudioCodes Mediant 3000 User Manual

SIP User's Manual

Metering Tone Parameters

A.12.9.3
The metering tone parameters are described in the table below.
Parameter
Web: Generate Metering
Tones
EMS: Metering Mode
[PayPhoneMeteringMode]
Charge Codes Table
[ChargeCode]
Version 6.4
Table A-61: Metering Tone Parameters
Determines the method used to configure the metering tones that are
generated to the Tel side.

[0] Disable = Metering tones aren't generated (default).

[1] Internal Table = Metering tones are generated according to the
device's Charge Code table (using the ChargeCode parameter).
Notes:

This parameter is applicable only to ISDN Euro trunks for sending
AOC Facility messages (see Advice of Charge Services for Euro
ISDN on page 320).

If you select 'Internal Table', you must configure the Charge Codes
table (see ChargeCode parameter).
This parameter table configures metering tones and their time intervals
that the device's or the E1 trunk (EuroISDN) sends in AOC Facility
messages to the PSTN (i.e., PBX).
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Where,

EndTime = Period (1 - 4) end time.

PulseInterval = Period (1 - 4) pulse interval.

PulsesOnAnswer = Period (1 - 4) pulses on answer.
For example:
ChargeCode 1 = 7,30,1,14,20,2,20,15,1,0,60,1;
ChargeCode 2 = 5,60,1,14,20,1,0,60,1;
ChargeCode 3 = 0,60,1;
ChargeCode 0 = 6, 3, 1, 12, 2, 1, 18, 5, 2, 0, 2, 1;
Notes:

The parameter can include up to 25 indices (i.e., up to 25 different
metering rules can be defined).

To associate a charge code to an outgoing Tel-to-IP call, use the
Outbound IP Routing Table.

For configuring ini file table parameters, see 'Configuring ini File
Table Parameters' on page 88.
721
32. Viewing Syslog Messages
Description
November 2011