Assigning The Voip Lan Ip Address; Using Cli - AudioCodes Mediant 3000 User Manual

SIP User's Manual
2

Assigning the VoIP LAN IP Address

This section describes how to change the default VoIP LAN IP address for Simplex
configuration so that it corresponds to your networking scheme. To assign IP addresses to
High Availability (HA) configuration, see Assigning an IP Address for Mediant 3000 HA on
page 31.
The default VoIP LAN IP address is listed in the table below:
IP Address
Private IP Address
Subnet Mask
Default Gateway IP Address
You can use any of the following management tools to change the default VoIP LAN IP
address:

Embedded command line interface (CLI) - see 'Using CLI' on page

Embedded HTTP-based Web server - see 'Using the Web Interface' on page

Bootstrap Protocol (BootP) - see Using BootP/TFTP Server on page
2.1

Using CLI

The procedure below describes how to assign a VoIP LAN IP address, using CLI.
Notes:

To assign a LAN IP address using CLI:
1. Connect the RS-232 port of the device to the serial communication port on your
computer. For more information, refer to the Hardware Installation Manual.
2. Establish a serial communication link with the device using a terminal emulator
program (such as HyperTerminal) with the following communication port settings:
•
Baud Rate: 115,200 bps
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
Flow Control: None
Version 6.4
Figure 2-1: Default VoIP LAN IP Address

TP-6310 or TP-8410 Blade in Slot 1: 10.1.10.10

TP-6310 or TP-8410 Blade in Slot 3: 10.1.10.11 (only for
HA mode)
255.255.0.0
0.0.0.0
•
For HA mode, this method changes only the local, private IP addresses
of the blades. These IP addresses are used for maintenance and fallback
in case of a major problem preventing the device from operating in HA
mode.
•
To operate in HA mode, the "global" IP addresses must be configured in
the Multiple Interface table.
2. Assigning the VoIP LAN IP Address
Value
27
27
28
29
November 2011