AudioCodes Mediant 3000 User Manual page 680

Parameter
Web/EMS: Idle ABCD Pattern
[IdleABCDPattern]
Web/EMS: TDM Bus Clock
Source
[TDMBusClockSource]
EMS/Web: TDM Bus Local
Reference
[TDMBusLocalReference]
Web/EMS: TDM Bus Enable
Fallback
[TDMBusEnableFallback]
Web: TDM Bus Fallback Clock
Source
EMS: TDM Bus Fallback Clock
[TDMBusFallbackClock]
Web/EMS: TDM Bus Master-
Slave Selection
[TDMBusMasterSlaveSelection]
Web/EMS: TDM Bus Net
Reference Speed
[TDMBusNetrefSpeed]
Web: TDM Bus PSTN Auto
FallBack Clock
EMS: TDM Bus Auto Fall Back
Enable
SIP User's Manual
Defines the ABCD (CAS) Pattern that is applied to the CAS
signaling bus when the channel is idle.
The valid range is 0x0 to 0xF. The default is -1 (i.e., default
pattern is 0000).
Notes:

For this parameter to take effect, a device reset is required.

This parameter is applicable only when using PSTN interface
with CAS protocols.
Determines the clock source to which the device synchronizes.

[1] Internal = Generate clock from local source (default).

[4] Network = Recover clock from PSTN line.
Note: This parameter is not required when operating in BITS
mode.
Defines the physical Trunk ID from which the device recovers
(receives) its clock synchronization.
The range is 0 to the maximum number of Trunks. The default is
0.
Note: This parameter is applicable only if the parameter
TDMBusClockSource is set to 4 and the parameter
TDMBusPSTNAutoClockEnable is set to 0.
Defines the automatic fallback of the clock. This sets the fallback
clock method between primary and secondary BITS clock
references.

[0] Manual (default)

[1] Auto Non-Revertive

[2] Auto Revertive
Determines the fallback clock source on which the device
synchronizes in the event of a clock failure.

[4] Network (default)

[8] H.110_A

[9] H.110_B

[10] NetReference1

[11] NetReference2
Defines the SC/MVIP/H.100/H.110.

[0] SlaveMode = Slave mode (another device must supply the
clock to the TDM bus) or Master mode (the device is the clock
source for the TDM bus) or Secondary Master mode (for
H100/H110 Bus only). (Default.)

[1] MasterMode = H110A Master in Master mode.

[2] SecondaryMasterMode = H.110B Master.
Defines the NetRef frequency (for both generation and
synchronization).

[0] 8 kHz (default)

[1] 1.544 MHz

[2] 2.048 MHz
Enables the PSTN trunk Auto-Fallback Clock feature.

[0] Disable (default) = Recovers the clock from the E1/T1 line
defined by the parameter TDMBusLocalReference.
680
Description
Document #: LTRT-89712
Mediant 3000