AudioCodes Mediant 3000 User Manual page 742

Parameter
For the ETSI ISDN variant, the following Number Plan and Type combinations (Plan/Type) are
supported in the Destination and Source Manipulation tables:

0,0 = Unknown, Unknown

9,0 = Private, Unknown

9,1 = Private, Level 2 Regional

9,2 = Private, Level 1 Regional

9,3 = Private, PISN Specific

9,4 = Private, Level 0 Regional (local)

1,0 = Public(ISDN/E.164), Unknown

1,1 = Public(ISDN/E.164), International

1,2 = Public(ISDN/E.164), National

1,3 = Public(ISDN/E.164), Network Specific

1,4 = Public(ISDN/E.164), Subscriber

1,6 = Public(ISDN/E.164), Abbreviated
For the NI-2 and DMS-100 ISDN variants, the valid combinations of TON and NPI for calling and
called numbers are (Plan/Type):

0/0 - Unknown/Unknown

1/1 - International number in ISDN/Telephony numbering plan

1/2 - National number in ISDN/Telephony numbering plan

1/4 - Subscriber (local) number in ISDN/Telephony numbering plan

9/4 - Subscriber (local) number in Private numbering plan
Redirect Number IP -to-Tel Table
Web: Redirect Number IP -> Tel
EMS: Redirect Number Map IP to Tel
[RedirectNumberMapIp2Tel]
SIP User's Manual
22,03,$$,0,0,$$,2,$$,667,$$,0,$$,$$;
SourceNumberMapTel2Ip 0 =
10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
Notes:

This table parameter can include up to 120 indices.

The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight, LeaveFromRight,
Prefix2Add, and then Suffix2Add.

If the called and calling numbers match the
DestinationPrefix and/or SourcePrefix conditions, then
the RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add, LeaveFromRight, NumberType, NumberPlan,
and/or IsPresentationRestricted are applied.

An asterisk ('*') represents all IP addresses.

IsPresentationRestricted is set to 'Restricted' only if
'Asserted Identity Mode' is set to 'P-Asserted'.

Number Plan and Type can optionally be used in the
Remote Party ID header by configuring the
EnableRPIHeader and AddTON2RPI parameters.

To configure manipulation of source numbers for Tel-to-IP
calls using the Web interface, see 'Configuring Number
Manipulation Tables' on page 282).

For a description on using ini file table parameters, see
'Configuring ini File Table Parameters' on page 88.
This parameter table manipulates the redirect number for IP-
to-Tel calls. This manipulates the value of the SIP Diversion,
History-Info, or Resource-Priority headers (including the
reason the call was redirected).
742
Description
Document #: LTRT-89712
Mediant 3000