Web Parameters; A.2.2 Web Parameters - AudioCodes Mediant 3000 User Manual

A.2.2

Web Parameters

The Web parameters are described in the table below.
Parameter
Web: Deny Acces On Fail Count
[DenyAccessOnFailCount]
Web: Deny Authentication Timer
[DenyAuthenticationTimer]
Web: Display Login Information
[DisplayLoginInformation]
[EnableMgmtTwoFactorAuthentication] Enables Web login authentication using a third-party,
[HTTPport]
EMS: Disable WEB Config
[DisableWebConfig]
SIP User's Manual
Table A-11: Web Parameters
Defines the maximum number of login attempts after
which the requesting IP address is blocked.
The valid value range is 0 to 32768. The values 0 and 1
mean immediate block. The default is 3.
Defines the time (in seconds) that login to the Web
interface is denied for a user that has reached maximum
login attempts as defined by the
DenyAccessOnFailCount parameter. Only after this time
expires can the user attempt to login from the same IP
address.
The default is 0.
Enables display of user's login information on each
successful login attempt.

[0] = Disable (default)

[1] = Enable
smart card.

[0] = Disable (default)

[1] = Enable
When enabled, the device retrieves the Web user's login
username from the smart card, which is automatically
displayed (read-only) in the Web Login screen; the user
is then required to provide only the login password.
Typically, a TLS connection is established between the
smart card and the device's Web interface, and a
RADIUS server is implemented to authenticate the
password with the username. Thus, this feature
implements a two-factor authentication - what the user
has (the physical card) and what the user knows (i.e., the
login password).
Defines the LAN HTTP port for Web management
(default is 80). To enable Web management from the
LAN, configure the desired port.
Note: For this parameter to take effect, a device reset is
required.
Determines whether the entire Web interface is read-
only.

[0] = Enables modifications of parameters (default).

[1] = Web interface is read-only.
When in read-only mode, parameters can't be modified.
In addition, the following pages can't be accessed: 'Web
User Accounts', 'Certificates', 'Regional Settings',
'Maintenance Actions' and all file-loading pages ('Load
Auxiliary Files', 'Software Upgrade Wizard', and
562
Mediant 3000
Description
Document #: LTRT-89712