Show Arpentry - D-Link DGS-3100 SERIES Cli Manual

show arpentry

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the ARP table:
DGS3100# show arpentry
ARP timeout : 150 Seconds
Interface
-------------
System
System
Total Entries = 2
DGS3100#
config arp_aging time
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure ARP aging time:
To display the ARP table.
show arpentry {ipif system | ipaddress <ipaddr> | static }
The show arpentry command displays the current contents of the
Switch's ARP table.
ipif system <ipif_name 12> – The name of the IP interface, the end
node or station for which the ARP table entry was made, resides on.
ipaddress <ipaddr> – The network address corresponding to the IP
interface name above.
static – Displays the static entries to the ARP table.
None.
IP Address
----------------
10.6.41.33
10.6.41.49
To configure the age-out timer for ARP table entries on the Switch.
config arp_aging time <value 1-65535 >
The config arp_aging time command sets the maximum amount of
time, in minutes, that an ARP entry can remain in the Switch's ARP
table, without being accessed, before it is dropped from the table.
time <value 1-65535> – The ARP age-out time, in minutes. The
value may be in the range of 1-65535 minutes, with a default setting
of 20 minutes.
Only Administrator or operator-level users can issue this command.
DGS3100# config arp_aging time 30
Success.
DGS3100#
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual
MAC Address
-------------------------
00:00:b0:07:07:49
00:20:18:2a:56:18
Type
---------------
dynamic
dynamic
130