8. Place the adapter on a flat, static-protective surface.
9. If you are instructed to return the adapter, follow all packaging instructions, and
Removing a ServeRAID adapter from the PCI riser-card assembly
To remove a ServeRAID adapter from the PCI riser-card assembly, complete the
following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the server top cover (see "Removing the server top cover" on page
4. If you have the optional hot-swap rear hard disk drive cage installed, rotate it up
5. Remove PCI riser-card assembly 2 (see "Removing the PCI riser-card
6. Pull the release pin to unlock the retention latch; then rotate the retention latch
7. Carefully grasp the ServeRAID adapter by the edge and pull it out of PCI
v For 1U PCI riser-card assembly 2:
Note: For 1U PCI riser-card assembly 2, it only supports ServeRAID
adapters (see "Removing a ServeRAID adapter from the PCI riser-card
assembly").
use any packaging materials for shipping that are supplied to you.
on page 35.
external cables.
44).
(see "Rotating the optional hot-swap rear hard disk drive cage up" on page 46).
assembly" on page 46).
to the open position.
riser-card assembly 2.
For 2U riser card:
Chapter 2. Installing optional devices
53