5. Install the server into the rack enclosure and tighten the two front thumbscrews
6. Reconnect the external cables; then, reconnect the power cords and turn on the
Rotating the optional hot-swap rear hard disk drive cage up
To rotate the optional hot-swap hard disk drive cage up, complete the following
steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 145).
to secure the server in the rack.
Attention:
Two or more people are required to install the system in a rack
cabinet.
peripheral devices and the server.
3
1
on page 133.
external cables.
2
Chapter 5. Removing and replacing server components
1
147