Hot-Swap Hard Disk Drive Cage - IBM xSeries 205 Type 8480 Hardware Maintenance Manual And Troubleshooting Manual

6. Lift the processor up and out of the computer.
7. To install a processor, reverse the previous steps.

Hot-swap hard disk drive cage

Before you begin:
v Read "Safety information" on page 117.
v Review the information in "System reliability considerations" on page 33.
Note: The illustration above may differ slightly from your server.
To remove the hot-swap hard disk drive, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server.
3. Remove the front bezel. See "Removing the front bezel" on page 67.
4. Remove the side cover. See "Removing the side cover" on page 40.
5. Remove the support-bracket assembly. See "Removing the side cover" on
6. Remove any hard disk drives or drive fillers from the drives.
7. Disconnect the hard disk drive cables that connect to the system board.
8. Remove the screws from the front of the hard disk drive cage.
9. Move the cage slightly in and up until it is free of the chassis and lift it out of the
Note: When reconnecting the fansink cable to the system board, be sure to
connect the cable to the connector marked "CPU fan".
page 40.
server.
Note: Take care not to dislodge the memory when you remove the cage.
Chapter 5. Field replaceable units
71