Replacing A Scsi Hot-Swap Hard Disk Drive; Replacing The Battery - IBM HS40 - BladeCenter - 8839 Maintenance And Troubleshooting Manual

Replacing a SCSI hot-swap hard disk drive

If a hard disk drive in the storage expansion unit fails, you can replace it without
turning off the blade server.
Complete the following steps to replace a SCSI hot-swap hard disk drive in a
storage expansion unit hot-swap bay.
Note: The illustrations used in this procedure depict the installation process on a
Attention:
unit for more than 1 minute without either a hot-swap hard disk drive or a filler
panel installed in each storage expansion unit bay.
1. Review the safety information beginning on page 109 and "Installation
2. Locate the defective hard disk drive (look for an amber status LED on the front
3. Make sure that the hard disk drive has stopped spinning.
4. Move the handle on the hard disk drive to the open position (perpendicular to
5. Within 1 minute, install the replacement hard disk drive in the hot-swap bay (see

Replacing the battery

IBM has designed this product with your safety in mind. The lithium battery must be
handled correctly to avoid possible danger. If you replace the battery, you must
adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
If you replace the original lithium battery with a heavy-metal battery or a battery with
heavy-metal components, be aware of the following environmental consideration.
BladeCenter HS40 blade server in a BladeCenter Type 8677 unit. These
illustrations might differ slightly from your hardware. However, this installation
process is the same regardless of the BladeCenter unit.
Hard disk drive
Filler panel
To maintain proper system cooling, do not operate the BladeCenter
guidelines" on page 33.
of the hard disk drive).
the hard disk drive), and pull the hot-swap hard disk drive assembly from the
bay.
"Installing a SCSI hot-swap hard disk drive" on page 57 for instructions).
Blade server
Storage
expansion unit
Chapter 4. Installing options
59