Installing The Usb Connection; Connecting The Analyzer To A Network - GE Sievers Innovox Operation And Maintenance Manual

Chapter 4: Installation
Figure 11: Connecting the Analyzer to a Network
To install the Ethernet connection, route the Ethernet cable through the Control port on the left side of the
Analyzer's enclosure. Pass the Ethernet cable twice through the ferrite (supplied in the Accessories Kit), as shown
in Figure 12. Then, insert the Ethernet cable into the Ethernet port on the System Controller Board.
Figure 12: Ethernet Cable Passing through Ferrite
You also will need to set up the IP Address for the Analyzer. For more information on network setup options, see
"Connecting the Analyzer to a Network Via Ethernet" on page 156 or "Configuring a Personal Computer" on
page 157.

Installing the USB Connection

The USB port is intended to provide data transfer to a USB flash memory drive or to a printer. The flash memory
drive can then be used with your computer's USB port to transfer exported data for import into a spreadsheet or
database program. The Analyzer cannot be directly connected to a computer via the USB port.
GE Analytical Instruments ©2016 87 of 270 DLM 68100-09 EN Rev. A