Table of Contents
Advertisement
Chapter 6: Analyzer Operation
Setting Up Input and Output (I/O)
The I/O Tab
Connecting the Analyzer to a Network Via Ethernet
The Analyzer can be connected to your network or directly to a personal computer via an Ethernet cable. If you
connect the Analyzer to your network, use a standard Ethernet cable. If you connect the Analyzer directly to a
personal computer, use an Ethernet crossover cable.
N
:
Consult with your Information Technology group to determine the best configuration for your
OTE
networking environment.
Configuring the Analyzer's IP Address
You must configure the Analyzer's Internet Protocol (IP) settings for use in connecting the Analyzer to a
computer network or directly to a computer.
To configure the Analyzer's IP Address
1.
Select the I/O tab, and then press the IP Configuration button. The Configuration screen appears.
GE Analytical Instruments ©2016
Figure 61: IP Configuration Screen
156 of 270
DLM 68100-09 EN Rev. A
Advertisement
Table of Contents
