Table of Contents
Advertisement
Chapter 4: Installation
12. Insert the ends of the U-bolt through the holes on the sensor, and then attach and secure a washer and
nut finger-tight. (Do NOT use an additional tool to tighten, as this may break the sensor.)
13. If you have the fail-safe option, repeat steps
14. Connect the pipe farthest from the instrument (the pipe without the internal sipper tube) to the sample
source. (See
Figure 19: Velocity Method — Installation on page
15. Connect the pipe nearest the instrument (the tube with the internal sipper tube) to the waste outlet.
(See
Figure 19: Velocity Method — Installation on page
To install the Wastewater Sampler (overflow method)
GE Analytical Instruments ©2016
Figure 21: Velocity Method — Failsafe Installation
10
through
Sipper
Tube
Figure 22: Overflow Method
94 of 270
12
for each stream.
93.)
93.)
DLM 68100-09 EN Rev. A
Advertisement
Table of Contents
