Table of Contents
Advertisement
Chapter 1. Installation and Wiring
1.1 Introduction
Users typically install the moisture.IQ as part of a complex process system, which includes components such as filters,
pumps, and pressure regulators. In such an environment, probes and other parts of the system may be subjected to
environmental hazards, such as high temperature, pressure extremes, corrosive elements and mechanical vibrations.
This section contains information and instructions for installing the moisture.IQ into a process system, while taking
into account all of the above factors. The following section describes how to set up and connect the moisture.IQ.
If you have questions about the installation procedures, contact our technical support department. See the rear cover of
this manual for contact information.
1.2 Unpacking the moisture.IQ
Before beginning the installation, unpack the unit and make sure all the parts and documentation listed on the packing
slip are included. Be sure to inspect each piece of equipment, including the sample system, for evidence of
mishandling. If anything has been damaged or is missing, report this to the carrier and to GE immediately.
1.3 Installing the moisture.IQ
To install the moisture.IQ, refer to the drawing for your specific configuration (benchtop, rack mount, panel mount,
weatherproof or explosion-proof) in the Certification and Safety Statements at the end of this manual.
WARNING! To ensure the safe operation of this unit, you must install and operate the moisture.IQ
as described in this user's manual. In addition, be sure to follow all applicable safety codes and
regulations for installing electrical equipment in your area.
WARNING! For Zone 2 Stainless Steel: Do not rub front face with a dry cloth within the hazardous
area as a spark may occur.
moisture.IQ User's Guide
Chapter 1. Installation and Wiring
1
Advertisement
Table of Contents
