Vlan - Funkwerk bintec R1200 Manual

Funkwerk Enterprise Communications GmbH
bintec R1xxx/R3xxx/R4xxx
Field
DHCP Hostname
Proxy ARP
TCP-MSS Clamping

7.2 VLAN

By implementing VLAN segmentation in accordance with 802.1Q, you can configure
VLANs on your device. The wireless ports of an access point, in particular, are able to re-
move the VLAN tag of a frame sent to the clients and to tag received frames with a pre-
defined VLAN ID. This functionality makes an access point nothing less than a VLAN-
aware switch with the enhancement of grouping clients into VLAN groups. In general,
VLAN segmenting can be configured with all interfaces.
Description
interfaces, the current MAC address is entered by default.
If you disable Use Built-In, you enter an MAC address for the
virtual interface, e.g. 00:e1:f9:06:bf:03 .
Some providers use hardware-independent MAC addresses to
allocate their clients IP addresses dynamically. If your provider
has assigned you an MAC address, enter this here.
Only if Address Mode = DHCP
Enter the host name requested by the provider. The maximum
length of the entry is 45 characters.
Select whether your device is to respond to ARP requests from
its own LAN on behalf of defined remote terminals.
The function is activated by choosing Enabled.
The function is disabled by default.
Select whether your device is to apply MSS Clamping. To pre-
vent IP packets fragmenting, the MSS (Maximum Segment
Size) is automatically decreased by the device to the value set
here.
The function is activated by choosing Enabled.
The function is disabled by default. Once enabled, the default
value 1350 is entered in the input field.
7 LAN
187