Umts / Hsdpa - Funkwerk bintec R1200 Manual

Funkwerk Enterprise Communications GmbH
bintec R1xxx/R3xxx/R4xxx
Field
Layer 2 Mode
Interface Leads

6.7 UMTS / HSDPA

Description
The detected value is displayed, e.g. Unknown
(Autodetected).
If you select the Detection Mode Interface or Manual, you
must set the connector type field manually.
Possible values:
• DTE: The pins are assigned as DTE interface. This setting is
necessary, for example, if the router is connected to a public
data network like Datex-P in Germany.
• DCE: The pins are assigned as DCE interface.
Define the value of the HDLC address field in the transmitted
command frames (Layer 2).
Possible values:
• Automatic (default value): The selection made for connect-
or is applied. You can usually accept this setting, e.g. for ac-
cess to a public data network such as Datex-P.
• DTE: The address field has the value for DTE.
• DCE: The address field has the value for DCE.
Define whether the gateway checks the status of the interface
lines. The same value should be set for both connection part-
ners.
Possible values:
• Enabled. The Layer 1 signalling of the remote terminal is
checked on the signal line (I for X.21, CTS for V.35). The
check correspondingly affects the variable L1State.
• Disabled (default value): The Layer 1 signalling of the re-
mote terminal is not checked, your gateway assumes that the
physical line is always "up". In this setting, you should monitor
the interface line in some other way, e.g. with PPP Keepalive.
6 Physical interfaces
181