Funkwerk bintec R1200 Manual page 238

9 Routing
224
Field
Fields in the IP Routes Extended Route Parameters menu
Field
Source Interface
Source IP Address
Layer 4 Protocol
Source Port
Funkwerk Enterprise Communications GmbH
Description
The lower the value, the higher the priority of the route.
Value range from 0 to 15, The default value is 1.
Description
Select the interface over which the data packets are to reach
the device.
The default value is None.
Enter the IP address and netmask of the source host or source
network.
Select a protocol.
Possible values: ICMP , TCP , UDP , GRE , ESP , AH , OSPF ,
L2TP, ANY .
The default value is ANY.
Only if Layer 4 Protocol = TCP or UDP.
Enter the source port.
First select the port number range.
Possible values:
• Any (default value): The route is valid for all port numbers.
• Single: Enables the entry of a port number.
• Range: Enables the entry of a range of port numbers.
• Privileged: Entry of privileged port numbers: 0 ... 1023.
• Server: Entry of server port numbers: 5000 ... 32767.
• Clients 1: Entry of client port numbers: 1024 ... 4999.
• Clients 2: Entry of client port numbers: 32768 ... 65535.
• Not privileged: Entry of unprivileged port numbers: 1024
... 65535.
Enter the appropriate values for the individual port or start port
of a range in Port and, for a range, the end port in to Port.
bintec R1xxx/R3xxx/R4xxx