Funkwerk bintec R1200 Manual page 194

6 Physical interfaces
180
Field
Interface Type
Connector Type
Funkwerk Enterprise Communications GmbH
Description
Possible values:
• Interface and Connector (default value): The interface
and connector types are detected automatically.
• Interface: Only the interface type is detected automatically.
The connector type must be set manually.
• Connector: Only the connector type is detected automatic-
ally. The interface type must be set manually.
• Manual: Both the interface and connector type must be set
manually.
Define the interface type of the port used.
If you select the Detection Mode Interface and Connect-
or or Interface, the interface type is detected automatically.
The detected value is displayed, e.g. V.35 (autodetected).
If you select the Detection Mode Connector or Manual, you
must set the interface type field manually.
Possible values:
• None: The port is not used.
• X.21 with Termination: V.11 on all lines, 120-ohm ter-
minating resistor on critical input lines.
• V.35: V.35 on critical lines, V.28 on uncritical lines.
• V.36: V.11 on critical lines, V.10 on uncritical lines.
• X.21 bis: V.28 on all lines.
• X.21 without Termination: Unterminated V.11 on all
lines.
• RS-449: V.11 on critical lines, V.10 on uncritical lines (9-pole
or 37-pole sub-D plug).
• RS-530: V.11 on critical lines, V.10 on uncritical lines
(25-pole sub-D plug).
• RS-530a: V.11 on critical lines, V.10 on uncritical lines incl.
DTR and DSR (25-pole sub-D plug).
Define the connector type of the port used.
If you select the Detection Mode Interface and Connect-
or or Connector, the connector type is detected automatically.
bintec R1xxx/R3xxx/R4xxx