Funkwerk bintec R1200 Manual page 331

Funkwerk Enterprise Communications GmbH
bintec R1xxx/R3xxx/R4xxx
Field
Phase-2 Profile
Start mode
Fields in the Advanced Settings Advanced IP Options menu
Field
Back Route Verify
Proxy ARP
IPSec Callback
Description
.
For phase 2, select a profile already configured in the Phase-2
Profiles menu. You can also select the profile marked as the
default in Phase-2 Profiles: None (use Default
Profile).
Select how the peer is to be switched to the active state.
Possible values:
• On demand (default value): The peer is switched to the active
state by a trigger.
• Always on: The peer is always active.
Description
Select whether a check on the back route should be activated
for the interface to the connection partner.
The function is activated with Enabled.
The function is disabled by default.
Select whether your device is to respond to ARP requests from
its own LAN on behalf of the specific connection partner.
Possible values:
• Inactive (default value): Deactivates Proxy ARP for this
IPSec peer.
• Up or Dormant: Your device only responds to an ARP re-
quest if the status of the connection to the IPSec peer is Up
(active) or Dormant. In the case of Idle, your device only re-
sponds to the ARP request; the connection is not set up until
someone actually wants to use the route.
• Active Only: Your device responds to an ARP request only
if the status of the connection to the IPSec peer is Up (active),
i.e. a connection already exists to the IPSec peer.
11 VPN
317