Funkwerk bintec R1200 Manual page 355

Funkwerk Enterprise Communications GmbH
bintec R1xxx/R3xxx/R4xxx
Field
UDP Destination Port
The Advanced Settings menu consists of the following fields:
Fields in the Advanced Settings menu
Field
Local IP Address
Hello Interval
Minimum Time between
Retries
Description
termined.
By default, the Fixed option is disabled, which means that ports
are dynamically assigned to the connections that use this pro-
file.
If you want to enter a fixed port, enable the Fixed option. Select
this option if you encounter problems with the firewall or NAT.
The available values are 0 to 65535.
Enter the destination port number to be used for all calls based
on this profile. The remote LNS that receives the call must mon-
itor this port on L2TP connections.
Possible values are 0 ... 65535.
The default value is 1701 (RFC 2661).
Description
Enter the IP address to be used as the source address for all
L2TP connections based on this profile.
If this field is left empty, your device uses the IP address of the
interface used to reach Remote IP Address by the L2TP tun-
nel.
Enter the interval (in seconds) between the sending of two L2TP
HELLO messages. These messages are used to keep the tun-
nel open.
The available values are 0 to 255, the default value is 30. The
value 0 means that no L2TP HELLO messages are sent.
Enter the minimum time (in seconds) that your device waits be-
fore resending a L2TP control packet for which it received no re-
sponse.
The wait time is dynamically extended until it reaches the Max-
imum Time between Retries. The available values are 1 to
11 VPN
341