Funkwerk bintec R1200 Manual page 347

Funkwerk Enterprise Communications GmbH
bintec R1xxx/R3xxx/R4xxx
Field
The Advanced Settings menu consists of the following fields:
Fields in the Advanced Settings menu
Field
IP Compression
Alive Check
Description
Entry in Seconds: Enter the lifetime for phase 2 key in seconds.
The value can be a whole number from 0 to 2147483647 . The
default value is 28800.
Entry in kBytes: Enter the lifetime for phase 2 keys as amount
of data processed in Kbytes. The value can be a whole number
from 0 to 2147483647 . The default value is 0.
Description
Select whether compression is to be activated before data en-
cryption. If data is compressed effectively, this can result in
higher performance and a lower volume of data to be trans-
ferred. In the case of fast lines or data that cannot be com-
pressed, you are advised against using this option as the per-
formance can be significantly affected by the increased effort
during compression.
The function is activated with Enabled.
The function is disabled by default.
Select whether and how IPSec heartbeats are used.
A bintec IPSec heartbeat is implemented to determine whether
or not a Security Association (SA) is still valid. This function
sends and receives signals every 5 seconds, depending on the
configuration. If these signals are not received after 20 seconds,
the SA is discarded as invalid.
Possible values:
• Down : Your device sends and expects no heartbeat. Set this
option if you use devices from other manufacturers.
• Heartbeats (Expect only): Your device expects a
heartbeat from the peer but does not send one itself.
• Heartbeats (Send only): Your device expects no heart-
beat from the peer, but sends one itself.
• Heartbeats (send & expect): Your device expects a
heartbeat from the peer and sends one itself.
11 VPN
333