Fip-1.7 Exit Jam (Jam Or Pick Error) - Fuji Xerox DocuPrint 2050 Service Manual

Chapter 2 Troubleshooting
2.3 Level 2 FIP

FIP-1.7 Exit jam (Jam or pick error)

Procedure
- Initial check -
Are there errors such as use of parts in different
specifications, attachment error, damage,
transformation, dirt, or foreign object?
- Major check parts -
1
SENSOR ACTUATOR (mounted on the FUSER ASSY
CL CH), ROLL ASSY EXIT (mounted on the FUSER
ASSY CL CH), FUSER ASSY CL CH (PL7.1.15),
SENSOR EXIT (mounted on the FUSER ASSY CL CH),
PWBA MCU XFABK(B) (PL9.1.25)
Does paper remain in the SENSOR ACTUATOR?
2
- Check of paper entry to the ROLL ASSY EXIT -
Does paper normally enter between the ROLL ASSY
3
EXIT of the FUSER ASSY CL CH and the pinch roll?
Execute the test printing for visual check.
- SENSOR ACTUATOR check -
Does the SENSOR ACTUATOR run smoothly?
4
- Sensor Exit check - *
Does the Sensor Exit function normally?
5
Select [SENSOR/SWITCH CHECK] on the
DIAGNOSTIC MODE MENU.
*: Do not absolutely touch the powered parts, high-voltage output parts, and driving parts for check.
2-18
Check
Action
YES
Replace and
reattach the parts.
Remove the
paper.
Replace the
To step 4 FUSER ASSY CL
- There is a tool.
To step 5 Replace the
- There is no tool. FUSER ASSY CL
Go to FIP-2.5,
Sensor Exit error
Replace the
Go to FIP-2.5,
PWBA MCU
Sensor Exit error
XFABK(B)
NO
To step 2
To step 3
CH
CH