Connection; Activating - Fuji Xerox DocuPrint 2050 Service Manual

Chapter 2 Troubleshooting
2.4 How to use PC Diag.

2.4.1.2 Connection

1) Remove the COVER ASSY STACK. (See REP 1.7)
2) Remove the COVER ASSY CONTROLLER. (See REP 9.5)
3) Disconnect the PWBA MCU-sided connector of the flat cable connected to the PWBA MCU
XFABK(B) and ESS PWB.
4) Hung the hook of DIAG I/F BOARD to the frame as shown in illustration.
5) Connect the PC to the DIAG I/F BOARD with a parallel cable.

2.4.1.3 Activating

1) Execute the set up (Setup.exe) of diagnostic tool from the CD-ROM.
2) Double-click the Diag, the "Diagnostic and Software" is activated.
The device is then placed into the power-on ready state.
3) Turn the device power on.
CAUTION
2-38
Hook
to PC
In case of Windows2000 or XP, install software by the privilege of
Administrators.
DIAG I/F BOARD
AZS601CA