Chapter 4 Disassembly/Assembly and Adjustment
4.2 Disassembly/Assembly
REP5.11 KIT ROLL FEED ASSY (PL5.1.60) [ROLL FEED FRONT D (PL5.1.35)/ROLL ASSY
FEED REAR (PL5.1.36)/GEAR (PL5.1.45)]
<Removal>
1)
Remove the CASSETTE ASSY 250 CL from the printer.
NOTE
NOTE
2)
Erect the equipment with the rear side down.
3)
Push the COVER FEED ROLL from the back and release the hook.
4)
Release the hook and remove the GEAR. (Refer to PL5.45 on the parts list.)
5)
Remove the ROLL FEED FRONT D. (Refer to PL5.35 on the parts list.)
6)
Remove the ROLL ASSY FEED REAR. (Refer to PL5.36 on the parts list.)
4-48
For the next and later procedures, prepare a 3cm or higher bench.
Be careful not to touch the rubber of roll.
3cm or higher bench
3)
Hook
AZS456CA
AZS457CA