Paper Throughput; Warm-Up Time; Fpot (First Print Output Time) - Fuji Xerox DocuPrint 2050 Service Manual

6.1.7.8 Paper throughput

Paper type
A3 (SEF)
A4 (LEF)
A5 (LEF)
Plain paper B4 (SEF)
B5 (LEF)
Letter (LEF)
Legal 14 (SEF)
No.4 horizontal
envelope (SEF)
Envelope
Postcard Postcard (SEF)
Reply card (SEF)
Transparency A4 (LEF)
*1 When the paper counter is becoming 31 or more, the slow down mode starts.
- The paper counter counts all paper.
- When the time not printed passes ten minutes or more, the counter clears.

6.1.7.9 Warm-up Time

When the nominal voltage (100 V, 120 V or 220 V) is applied, the FUSER standby temperature
should be reached within the time stated below.
• From the moment of POWER ON to the start of Standby mode: 15 seconds or less
• When a mode change command is received from IOT during the Power Save mode: 15
seconds or less

6.1.7.10 FPOT (First Print Output Time)

FPOT time of the printer is shown in the table below.
The time required for the first sheet of paper to be delivered after the START command is
received.
File type
FPOT
Plain paper mode
Paper
ppm
11.5
21.0
18.0
12.0
21.0
19.5
7.8
--
--
--
--
J9
less than 19.5 sec.
slow down
ppm
-- Threshold
-- -- 11.5
-- -- 21.0
-- -- 18.0
-- -- 12.0
-- -- 21.0
-- -- 19.5
-- -- 7.8
-- -- 7.8
-- -- 9.0
-- -- 8.3
-- -- 21.0
J11
less than 19.5 sec.
Chapter 6 General
6.1 Specifications
Thick paper mode
slow down
-- Threshold
-- --
-- --
7.8 31 *1
-- --
-- --
-- --
-- --
4.1 31 *1
4.4 31 *1
4.2 31 *1
-- --
6-7