Fuji Xerox DocuPrint 2050 Service Manual page 36

<Continued from the preceding page>
Procedure
- PLATE DT SAW check -
Is the PLATE DT SAW dirty, dusty, or transformed?
9
- HEAT ROLL/PRESSURE ROLL rotation check -
10 Does the HEAT ROLL or PRESSURE ROLL of the
FUSER ASSY CL CH rotate normally?
- Check of paper entry to ROLL ASSY EXIT -
Does paper normally enter between the ROLL ASSY
11
EXIT of the FUSER ASSY CL CH and the pinch roll?
Execute the test printing for visual check.
- SENSOR ACTUATOR check -
Does the SENSOR ACTUATOR run smoothly?
12
- Sensor Exit check - *
Does the Sensor Exit function normally?
13
Select [SENSOR/SWITCH CHECK] on the
DIAGNOSTIC MODE MENU.
*: Do not absolutely touch the powered parts, high-voltage output parts, and driving parts for check.
Check
Chapter 2 Troubleshooting
2.3 Level 2 FIP
Action
YES
Replace/Clean
the PLATE DT
To step 10
SAW
Replace the
To step 11 FUSER ASSY CL
Replace the
To step 12 FUSER ASSY CL
- There is a tool.
To step 13- There Replace the
is no tool. Go to FUSER ASSY CL
FIP-2.5, Sensor
Exit error
Replace the
Go to FIP-2.5,
PWBA MCU
Sensor Exit error
XFABK(B)
NO
CH
CH
CH
2-17