Fuji Xerox DocuPrint 2050 Service Manual page 28

Error status
Cover open
Fuser alarm
ROS alarm
Scanner motor alarm
FAN alarm
Main motor alarm
BD alarm
Drum/toner cartridge
error
Drum/toner cartridge type
error
Contents or detection conditions
The cover is opened.
- The Front or Top Cover is opened.
Temperature error in fusing unit
1) The temperature exceeds the set
value after the Fuser warm up or
during printing.
2) The temperature becomes below the
set value at the standby.
3) The temperature becomes below the
set value at the printing.
4) The temperature of Power On
exceeds the temperature of 3 seconds
later.
5) Detects the thermistor is broken.
6) The temperature does not reach the
specified temperature within 20
seconds from the power-on.
ROS error
- The laser power does not reach the
specified value.
Scanner rotation error in ROS
1) The lock signal of the scanner motor
remains set on.
2) The lock signal of the scanner motor is
not set off within the specified time.
FAN rotation error
Main motor error
- The Main Motor does not rotate or
stop.
BD (Beam Detect signal) error
- The interval of BD0 signal is large
than the specified value.
The printer does not communicate with
the CRUM by the electrical trouble of the
Drum/toner cartridge.
A different type of Drum/toner cartridge
was detected.
Chapter 2 Troubleshooting
2.3 Level 2 FIP
Clear method
Close the Front or Top
Cover.
Turn the power on and off.
Turn the power on and off.
Turn the power on and off.
Turn the power on and off.
Turn the power on and off.
Turn the power on and off.
Turn the power on and off.
Attach the correct Drum/
toner cartridge.
2-9