Fip-P12 "Scattered Toner - Fuji Xerox DocuPrint 2050 Service Manual

FIP-P12 "Scattered toner"

Image data is printed with toner scattered.
- Initial check -
Are there errors such as use of parts in different
P12
specifications, attachment error, damage,
transformation, dirt or foreign object?
- Major check parts -
PLATE DT SAW (PL8.1.4), AZUSA HVPS (PL9.1.6),
ROLL BTR (PL8.1.14)
Item
1 Is the humidity too low?
2 Is the specified paper used?
Is paper stored in an appropriate place?
3
4 Is the PLATE DT SAW dirty?
Is the voltage applied to the PLATE DT SAW?
5
Is a foreign matter near the ROLL BTR?
6
Phenomenon/Initial check
Check
Chapter 3 Image Quality Troubleshooting
Adjust the humidity.
Use the specified paper.
Improve the paper storage
environment.
Clean the PLATE DT SAW.
Check the contacts of the high-
voltage terminals. When they are
not normal, repair them. When
they are normal, check the state
of the high-voltage power;
otherwise, replace the AZUSA
HVPS.
Clean near the ROLL BTR, then
remove the foreign object and
clean the dirty parts.
3.5 Image Quality FIP
Print sample
Action
(at occurrence of error)
3-25