Network Conference; Call Park - Yealink SIP VP-T49G User Manual

4. Click Confirm to accept the change.
Note
Network conference is configurable via web user interface only.
To set up a network conference call:
1. Place a call to the first party.
2. Tap the Conference soft key to place a new call.
The active call is placed on hold.
3. Enter the number of the second party and press
4. When the second party answers the call, tap the Conference soft key to add the
second party to the conference.
5. Tap the Conference soft key to place a new call.
The conference call is placed on hold.
6. Enter the number of the new party and then press
7. When the new party answers the call, tap the Conference soft key to add the new
party to the conference.
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call on specific servers may be different
from introduced above. Contact your system administrator for more information.
You can use call park to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You
can park an active call by tapping the call park key on the phone. If the call is parked
successfully, the response is either a voice prompt confirming that the call was parked,
or a visible prompt on the touch screen.
Note Call park is not available on all servers. Contact your system administrator for more
information.
To configure a call park key via phone user interface:
1. Tap -> Features->DSS Keys.
2. Tap the desired line key.
3. Tap the Type field.
4. Tap Key Event in the pop-up dialog box.
5. Tap the Key Type field.
6. Tap Call Park in the pop-up dialog box.
Basic Phone Features
or tap the Send soft key.
or tap the Send soft key.
197