Yealink SIP VP-T49G User Manual page 217

Attended Transfer

New Call

To perform a blind transfer:
When the transfer mode on DSS key is set to Blind Transfer and there is already an
active call on the IP phone, you can do the following:
1. Tap the BLF key of the monitored user which you want to transfer this call to.
Then the active call is connected to the number of the monitored user.
To perform a semi-attended transfer:
When the transfer mode on DSS key is set to Attended Transfer and there is already an
active call on the IP phone, you can do the following:
1. Tap the BLF key of the monitored user which you want to transfer this call to. The
phone will dial the number of the monitored user.
2. Tap the BLF key of the monitored user again or the Transfer soft key to complete the
transfer when receiving ringback.
To perform an attended transfer:
When the transfer mode on DSS key is set to Attended Transfer and there is already an
active call on the IP phone, you can do the following:
1. Tap the BLF key of the monitored user which you want to transfer this call to. The
phone will dial the number of the monitored user.
2. Tap the BLF key of the monitored user again or the Transfer soft key to complete the
transfer after the monitored user answers the call.
To perform a new call:
When the transfer mode on DSS key is set to New Call and there is already an active
call on the IP phone, you can do the following:
1. Tap the BLF key of the monitored user you want to call.
The phone will dial the number of the monitored user.
When the monitored user receives an incoming call, the BLF key LED of the monitored
user will fast flash. If you enable visual and audio alert features on the phone, the phone
will play a warning tone and display the incoming call information on the touch screen.
You can use the BLF key to pick up an incoming call of the monitored user. Before picking
up an incoming call, ensure that the call pickup code has been configured in advance.
Advanced Phone Features
217