Yealink SIP VP-T49G User Manual page 233

Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call
while there is already an active call on the phone. If Intercom Barge is enabled, the
phone will automatically answer the intercom call and place the active call on hold. If
Intercom Barge is disabled, the phone will handle an incoming intercom call like a
waiting call. Intercom Barge is disabled by default.
Note
To enable the phone to receive a new incoming call when it has an active call, make sure
that call waiting feature is enabled on the phone in advance. For more information, refer
Call
to Waiting
To configure intercom features via phone user interface:
1. Tap ->Features->Intercom.
2. Make the desired changes.
3. Tap the Save soft key to accept the change or
These specific parameters are configurable via web user interface at the path
Features->Intercom.
To place an intercom call when the target phone is idle:
1. Tap the intercom key when the phone is idle.
The called destination plays a warning tone and automatically answers the call in
the speakerphone mode by default.
2. To end the intercom call, tap the intercom key again or the EndCall soft key.
on page 192.
Advanced Phone Features
to cancel.
233