External Monitor - Yealink SIP VP-T49G User Manual

User Guide for SIP VP-T49G IP phone
You can use two headsets when dual headset feature is enabled. To use this feature,
you must physically connect headsets to the headset jack and handset jack respectively.
Once the phone connects to a call, the headset connected to the headset jack will have
full-duplex capabilities, while the one connected to the handset jack will only be able to
listen.
To enable dual headset via web user interface:
1. Click on Features->General Information.
2. Select Enabled from the pull-down list of Dual-Headset.
3. Click Confirm to accept the change.
Note
Dual headset is configurable via web user interface only.
During a video call, the video image captured from the camera (both near-site and
far-site) will also be shown on the external monitor. If you change the video layout on
the IP phone, the content displayed on the external monitor will change as well. If the
phone is not in a video call, the external monitor will display a Yealink logo.
Before using the external monitor, ensure that the external monitor has been connected
to your phone. For more information, refer to
SIP VP-T49G IP phone supports the following video resolutions on both IP phone and

external monitor:

Single channel video calls
108
Scenario
Phone Installation
Resolution
Receive
1920 x 1080 (1080P)
on page 25.
Send
1920 x 1080 (1080P)