Yealink SIP VP-T49G User Manual page 27

4) Connect the AC power
Connect the DC plug on the power adapter to the DC12V port on the phone and
connect the other end of the power adapter into an electrical power outlet.
Note
Important! Do not remove power to the phone while it is updating firmware and
configurations.
The IP phone should be used with Yealink original power adapter (12V/2A) only.
5) Connect the optional USB flash drive
When you attach a USB flash drive to your phone, the icon
bar of the touch screen. The flashing icon shows that the phone is detecting the USB
flash drive. If the USB flash drive is successfully connected to the phone, the icon
stop flashing, and the touch screen will prompt ―USB device connected successfully!‖.
Note
The USB flash drive should be purchased separately if required.
6) Connect the optional external monitor
Remove one piece of the fastener's liner, take the gap of the camera as the
-
Getting Started
will display on the status
will
27