Adjusting The Mower Deck Front-To-Rear Pitch; Checking The Mower Deck Side-To-Side Height - Toro 30284 Service Manual

MOWER DECKS
Adjusting the Mower Deck Front-to-
Rear Pitch
Changing the front-to-rear pitch is done by adjusting the
front height-of-cut posts.
1. To raise the front of the deck, loosen the jam nut
on the lower end of the deck hanger pin assembly.
Rotate the front pin clockwise (Fig. 1387).
2. To lower the front of the deck, loosen the jam nut
on the lower end of the deck hanger pin assembly.
Rotate the front pin counter-clockwise (Fig. 000).
3. Position the mower blades in the front-to-rear ori-
entation. Measure at the AA and BB locations (Fig.
1385 and Fig. 1386) from a level surface to the
cutting edge of the blade tips.
4. Check the side-to-side leveling of the cutting unit.
Refer to Checking the Mower Deck Side-to-Side
Height.
5. Tighten the jam nuts (Fig. 1387).
8
A. Caster wheel
B. Carrier Frame
C. Front height-of-cut pins
8-66
B
D
C
E A
Fig 1387 fi g. 84 G000292
D. Jam nut
E. Ball joint
Checking the Mower Deck Side-to-
Side Height
1. Adjust the rear tire pressure to 12-14 psi (83-97kPa).
2. Position the mower blades in the side-to-side orien-
tation. Measure at the C and D locations from a level
surface to the cutting edge of the blade tips (Fig.
1388 and for 36" mower decks use Fig. 1389).
3. The difference between the measurements at the C
and D locations should be no more than 1/4" (6mm).
4. If the side-to-side pitch is not correct, proceed to
Adjusting the Mower Deck Side-to-Side Height.
C
Fig 1388
This illustration shows a 40", 48" and 52" mower deck.
A. Measure from a level
surface
Floating Deck Mid-Size Service Manual
D
B
A
fi g. 85 G004908
B. Measure blade at points
C and D