Mower Deck Maintenance; Leveling The Mower Deck - Toro Z Master Professional 6000 Series Operator's Manual

Figure 87
Bottom view of the machine
1. Filter locations
6. Apply a thin coat of hydraulic oil to the rubber gasket
on the replacement filter (Figure 87).
7. Install the replacement hydraulic filter.
8. Install the pump-drive belt and the mower belt.
9. Remove the jack stands and lower the machine (Figure
86).
10. Add oil to the hydraulic reservoir and check for any
leaks.
11. Clean up any spilled oil.
12. Start the engine and let it run for about 2 minutes to
purge air from the system.
13. Stop the engine and check for leaks.
14. Check the oil level while the oil is cold.
15. If required, add oil to the hydraulic reservoir.
Note: Do not overfill.
1
2
G008968
2. Hydraulic filter
Mower Deck
Maintenance

Leveling the Mower Deck

Setting up the Machine
Note: Ensure that the mower deck is leveled before
matching the height-of-cut (HOC).
1. Position the mower on a flat surface.
2. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-locked position,
and set the parking brake.
3. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
4. Check tire pressure of the drive tires.
5. If needed, adjust to 90 kPa (13 psi).
6. Position the mower to the 76 mm (3 inches)
height-of-cut position.
Leveling the Deck
1. Position the mower on a flat surface.
2. Stop engine, wait for all moving parts to stop, remove
the key, and engage the parking brake.
3. Check the tire pressure in the drive tires.
Note: Proper inflation pressure for the tires is 90 kPa
(13 psi).
4. Position the transport lock in the latching position.
5. Push the deck-lift pedal all the way forward and the
deck will latch at the 14 cm (5-1/2 inches) transport
position (Figure 88).
57