Submenu Display; Printer Information - Canon imagePROGRAF iPF8000S User Manual
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Control Panel
Submenu Display
Press the Information button to display this information, one after another: the Maintenance Cartridge
capacity and remaining ink levels, paper information, and printer information.
Each time you press the Information button, the following submenus are displayed.
Note
•
Press any button other than the Information button to restore the previous mode.
•
After you display a submenu, the printer will revert to the previous mode in about ve seconds if no print
job is received or if you do not operate the printer.
Remaining Maintenance Cartridge capacity and ink levels
The remaining Maintenance Cartridge capacity is shown on the top level of the Display Screen.
The remaining level of each ink is shown on the bottom level of the Display Screen. Ink levels shown on the
Display Screen correspond to the inks identied by the color labels on the bottom of the Display Screen.
These symbols may be displayed above the ink level: "!" if ink is low, "×" if no ink is left, and "?" if you have
deactivated ink level detection.
Remaining ink is indicated as follows.
Information of the loaded paper
Here, the paper size, type, and related printer settings are displayed.
Printer information
Displays the rmware version, serial number, IP address, and hard disk capacity.
68 Printer Parts
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated