Canon imagePROGRAF iPF8000S User Manual page 671
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
3.
In the Settings dialog box, specify the password and click OK.
•
Set password : Select the check box.
•
Password : Enter the password. (This eld is limited to four digits in the range 0001-9999.)
•
Re-enter to conrm : Re-enter the password to conrm it.
For details, refer to the imagePROGRAF Status Monitor help le.
Using imagePROGRAF Printmonitor (Mac OS)
1.
In the Hard Disk pane, click "►" next to Inbox No./Name to list saved jobs. Select a saved
job and click Set.
2.
In the Settings dialog box, specify the password and click OK.
•
Set password : Select the check box.
•
Password : Enter the password. (This eld is limited to four digits in the range 0001-9999.)
•
Verify : Re-enter the password to conrm it.
For details, refer to the imagePROGRAF Printmonitor help le.
Advanced Print Job Operations
Print Jobs 655
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated