The Printer Consumes A Lot Of Ink - Canon imagePROGRAF iPF8000S User Manual
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Other problems
Messages advising to check the maintenance cartridge
are not cleared
The printer has not detected the new Maintenance
Cartridge that was used to replace the old one.
The printer consumes a lot of ink
Many full-page color images are printed.
Head Cleaning B is used often.
You have just nished initial installation, when more
ink is consumed to ll the system.
780 Troubleshooting
Cause
Cause
Corrective Action
Remove the new Maintenance Cartridge you have
just installed and insert it again rmly.
Restart the printer.
Corrective Action
In print jobs such as photos, images are lled with
color. This consumes a lot of ink. This does not
indicate a problem with the printer.
Head Cleaning B consumes a lot of ink. This does
not indicate a problem with the printer. Unless the
printer has been moved or stored for a long period
or you are troubleshooting Printhead problems, we
recommend not performing Head Cleaning B, to the
extent possible.
After initial installation or at the rst-time use after
transfer, ink ows into the system between the Ink
Tank and Printhead, which may cause the ink level
indicators to drop to 80%. This does not indicate a
problem with the printer.
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated