Canon imagePROGRAF iPF8000S User Manual page 59
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
First Level
Second Level
Third Level
5 sec.
7 sec.
9 sec.
Feed Priority
Automatic *
Band Joint
Print Length
Adjust Length
From -0.70% to
0.70%
Head Height
Automatic *
Highest
High
Standard
Low
Lowest
Skew Check Lv.
Standard *
Loose
Off
VacuumStrngth
Automatic *
Strongest
Strong
Standard
Weak
Weakest
Width Detection
Off
On *
NearEnd RollMrgn 5mm
20mm
Cut Speed
Fast
Standard
Slow
Trim Edge First
Automatic
Off
On
Cutting Mode
Automatic
Eject
Fourth Level
Fifth Level
Control Panel
Printer Parts 43
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated