Canon imagePROGRAF iPF8000S User Manual page 594
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Printmonitor
Note
•
If the status of the desired printer is not shown in imagePROGRAF Printmonitor, select the printer
again as follows.
1.
Make sure the printer is on and connected to the network or to a local port.
2.
In the Printer menu, select the name of the desired printer.
After the printer is detected, the printer status is shown.
3.
If information about the printer is not shown in step 2, choose Search Printer in the Printer menu.
4.
Select the zone to search (or select *(My Zone) if no zones have been set up) and click the
Search button.
Printer names listed in the Printer menu are updated with the printers that are now detected.
5.
In the Printer menu, select the name of the desired printer.
After the printer is detected, the printer status is shown.
578 Mac OS 9 Software
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated