Canon imagePROGRAF iPF8000S User Manual page 73

Setting Item
(The type of paper is
displayed here.)(*1)
*1: For information on the types of paper the printer supports, refer to the Paper Reference Guide.
(→P.109) The type of paper indicated in the printer driver and related software (as well as on the
Control Panel) is updated when you install the printer driver from the User Software CD-ROM or if you
update paper information by using the Media Conguration Tool.
Trim Edge First
Cutting Mode
Bordless Margin
CutDustReduct.
NearEnd Sht Mrgn
Return Defaults
Description, Instructions
If a roll is loaded, the end of the paper will be cut.
Choose On to have 40 mm (1.6 in) cut off the leading
edge of the roll after you load the roll. Scraps are
then removed.
When Automatic is selected, if the left and right side
of the leading edge of the roll are uneven (by 3 mm
[0.12 in] or more), the edge is cut an amount relative
to the slant to ensure a straight edge after you load
the roll. Scraps are then removed.
If the unevenness is less than 3 mm or if Off is
selected, the edge is not cut and scraps are not
removed.
Specify whether or not to cut with the standard
round-bladed cutter.
Choose Automatic to have the roll cut automatically
after printing. If you choose Eject, the paper is cut
after you hold down the Stop button for a second
or more. If you choose Manual, the paper will not
be cut after printing. Instead, a line will be printed
at the cut position.
Adjust the margin during borderless printing.
Choose Automatic to have the printer automatically
detect the paper width and congure the margin
settings for borderless printing. If margins are
mistakenly created when Automatic is selected,
choose Fixed. In this case, the paper width is not
detected automatically, and the document is printed
without borders, using the margin settings required
by the printer.
Choose On to reduce the amount of debris generated
when cutting lm and similar media by printing a line
at the cut position. This option reduces the amount
of debris given off after cutting. It also helps prevent
adhesive from sticking to the cutter and keeps the
cutter sharp if you use adhesive paper. (→P.144)
Specify a margin at the leading edge of sheets to
ensure better printing quality at the leading edge.
Note that if you choose 3mm, it may lower the
printing quality at the leading edge and affect feeding
accuracy. The printed surface may be scratched, and
ink may adhere to the leading edge.
Choose Yes to restore Paper Details to the default
values.
Control Panel
Printer Parts 57