Printing By Using Custom Size - Canon imagePROGRAF iPF8000S User Manual
Hide thumbs
Also See for imagePROGRAF iPF8000S:
- Service manual (334 pages) ,
- Questions and answers (36 pages) ,
- Brochure (8 pages)
Table of Contents
Advertisement
Printing on Non-Standard Paper Sizes (Windows)
This topic describes two ways to print on non-standard paper sizes.
•
Printing by using Custom Size (→P.365)
•
Printing by using Custom Paper Size (→P.367)
Printing by using Custom Size
This section describes how to print using Custom Size based on the following example.
•
Document: Scanned image
•
Page size: Square of non-standard dimensions (430 × 430 mm [16.9 × 16.9 in])
•
Paper: Sheets
•
Paper type: Plain Paper
•
Paper size: A square sheet (430 × 430 mm [16.9 × 16.9 in])
1.
Load the square paper (430 × 430 mm [16.9 × 16.9 in]) in the printer.
2.
Choose Print in the application menu.
3.
Select the printer in the dialog box, and then open the printer driver dialog box. (→P.482)
4.
Make sure the Main sheet is displayed.
5.
A
In the
Media Type list, select the type of paper that is loaded. In this case, click Plain Paper.
6.
After conrming that
list.
D
Easy Settings is selected, click Scanned Image in the
Printing banners or at other non-standard sizes
Enhanced Printing Options 365
E
Print Target
- Quick Links:
- Print Area
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the imagePROGRAF iPF8000S and is the answer not in the manual?
Questions and answers
how so you get to initialize on canon program Ipf8000s
To initialize the Canon imagePROGRAF iPF8000S, you can configure its IP address using the imagePROGRAF Device Setup Utility by following these steps:
1. Start the imagePROGRAF Device Setup Utility from the Start menu.
2. Select the printer from the Device Name list.
3. Choose "Protocol Settings" from the Printer menu.
4. In the "Setting IP Address" list, select "Manual".
5. Enter the assigned IP address and click the "Set" button.
6. Click "OK" when the confirmation message appears.
7. Exit the utility.
Alternatively, to configure the IP address automatically, choose "Auto" and select DHCP, BOOTP, or RARP. You can also set the subnet mask and default gateway.
This answer is automatically generated